Just a couple of pics to show the solution for the radius requirement for the IVA. If the bottom of the dash is a hard edge it needs minimum 20mm radius so I cut a slot in a bit of 20mm O.D. aluminium tube and wedged it on the bottom of the dash. The tube will get covered in black vinyl when we get round to it.
Also, interestingly. it seems the gear lever is a lot further forward with a tremec box so if you are using the Dax dashboard rather than making your own you may need to check clearance to the dash of the gear stick when in 1/3/5th gear. This isn't a problem with the getrag box as the gear lever is miles away
Update 14/10/13 to add picture of lower IVA rail with a bit of vinyl around it. Doesn't look half bad, the vinyl is held on with some double sided trim tape and just needs tweaking a little where its rucked up.
No comments:
Post a Comment